Sonance Sonamp – 260x3
Normally this model should power 3 pairs of Speakers, however one of the three pairs of channels does not work and I don't have the expertise to fix it, hence the low price of $75. Other than that, the other two Stereo channels and the rest of the amp's features work perfectly.

This amp is stable down to 2.7 ohms. (I believe that two pairs of 8 ohm speakers – in parallel – represent a load of 4 ohms which this amp can very easily handle without overheating or any distortion.)

Specifications
Power output: 60 WPC at 8 ohms,100 WPC at 4 ohms and 125 WPC at 2 ohms X 2 Pairs of speakers.
Dynamic Power = 85/120/140 wpc at 8/4/2 ohms.

Push buttons allow you to choose one or the other pair or both together and there is also the ability to fine tune the left and right volume output. Several protection circuits safeguard the amplifier against overload, overheating, or output short circuits. This amp also has an Auto on/off switch. When set to ON, the amp turns on within 1.5 seconds of receiving a signal. After 2 minutes, if there is no input signal, the amp will automatically shut down and return to a stand-by mode.

Frequency response: 20Hz to 20kHz with total Harmonic Distortion: 0.05%
Input sensitivity: 0.625V
Signal to noise ratio: 100dB
Speaker load impedance: 2.7Ω (minimum)
Large Toroidal transformer with 30,000 microfarads (μF) of filter capacitance
Line Output jacks (in addition to input jacks) in case you wanted or needed to add an additional amp

4 Way Binding Posts (incl Banana plugs)

Dimensions: 16.75 x 3.5 x 12.5 inches
Weight: approx 16.8 lbs
When you call please mention you found this ad listing on OKz.ca