The PSB Image 5T Floor-Standing Speakers are tall 3-Driver towers with dual front ports and a modern appearance.

The tweeter is a 1” aluminum dome with ferrofluid, a 6.5” mid-range/bass driver and the same for a bass unit, each with rubber surrounds. Each of the two 6.5” drivers has a 2”vented port. Crossovers are a Linkwitz-Riley 4th order at 500 Hz between the two 6.5” drivers, and a 3rd order Butterworth at 2.5 kHz leading up to the tweeter.

The two and a half way design is intended to produce coherent sound from proximate drivers. In other words, the 1” tweeter is next to the 6.5” driver that picks up where the tweeter leaves off, thus that range of sound comes from about the same area in the front baffle. The lower 6.5” driver plays only below 500 Hz and thus integrates with the middle driver.

Sensitivity is quite high, rated at 92 dB in a typical room and 90 db in an anechoic chamber.

The top of the front baffle is a curved plastic molding that houses the drivers. The grille is set on a rigid plastic frame that is curved to fit the baffle. Black plastic feet hug the bottom sides giving a smart appearance, and adding to stability. A dual set of gold plated binding posts with plastic fasteners are set on the bottom of the rear panel, thus allowing for bi-wire or bi-amp configurations.

Driver Complement: One 1" Aluminum Dome Tweeter, Two 6 1/2" Polypropylene Woofers, Bass-Reflex

MFR: 35 Hz - 21 kHz ± 3 dB,

Sensitivity: 92 dB/w/m

Power Handling: 10 - 175 Watts, 250 Watts Peak,

Impedance: 6 Ohms Nominal

Dimensions: Size: 36" H x 8" W x 14 1/4" D, Weight: 42 Pounds Each

Finish: Black Ash

Asking just $595 for these great sounding Canadian made floorstanders from PSB

Please take a look at our other ads

Discounts:

5% off 2 pieces of stereo equipment
10% off 3 pieces
15% off 4 pieces
20% off 5 or more pieces

To view our other listings, please click the link "View poster's other Ads" at the far right, just below our phone number.
When you call please mention you found this ad listing on OKz.ca