This is a lot, after giving it a read if you have any questions please don't hesitate to ask.

I will not ship this. Local pickup only.

Software:
- Running Marlin 2.1.2.5 firmware
-- You can flash it back to Creality's Firmware if you want: https://www.crealitycloud.com/downloads/firmware/cr-series

Hardware:
- CR 10 V3
-- 300mm x 300mm x 400mm build volume
-- Direct Drive
-- 0.4mm nozzle
- Sovol 3D Filament Dryer
-- Holds two spools at the same time
- Raspberry Pi 4 (4GB), power supply, USB cables
-- I used this for Octoprint
-- The case it is in has active cooling (a fan)
-- No SD card is provided
-- No network cable is provided
- Microsoft Studio Webcam (1080p) USB extension cable
-- I connected this to the RPi so I could monitor printers remotely

Upgrades:
- Noctua Fans (Tool Fan, Power Supply Fans, Solvol 3D Filament Dryer Fan)
- Part cooling fan has recently been replaced and is nearly brand new
- BL Touch bed leveling probe
- Hictop Textued PEI removable magnetic bed
-- Original double sided glass bed also provided
- Capricorn bowden tubing plus plenty of spare

Everything else:
- Lots of spare parts and tools
- Desicant beads to keep stored filament dry
-- Spent beads can be baked in the oven to refresh them
-- Multiple holders that thread through the center of the spool
- Unopened Filament
-- 2x EconoFil SILK PLA (Silver)
-- 1x Canadian Filaments PLA (Pumpkin Orange)
-- 1x True FoodSafe PLA (Blue)
- Partially used Filament
-- 1x Canadian Filaments PLA (Deep Blue)
-- 1x True Food Safe PLA (Silver Ice)
-- 1x Overture PETG (Silver)
-- 1x Eryone Glow in the dark PLA (Green)
-- 1x TPE85A (Green)
-- 1x Ninjatek Cheetah TPU (Flamingo (Pink))
-- 1x Canadian Filaments PLA (White with grey speckles)
When you call please mention you found this ad listing on OKz.ca