STORE LOCATION: 545 TELFER St S, Winnipeg, MB R3G 2Y4

https://altitudoaudio.ca/products/unison-research-max-2

This new Unison Research model is designed to be matched, in particular, to the Unison Research valve amplifiers. For this purpose not only the sensitivity but also the impedance were optimized. The MAX_2 is a two-way floor standing, reflex loaded system, of important size however compact. The reflex ducts is front firing to make easier to place the diffusers in the room. This speaker can also be used as front channel in home theater systems. With two pairs of diffuser (front and rear) you get an high- impact home theater system that does not require a center channel or sub-woofer.


This is undoubtedly a definitive loudspeaker with: full extension of the low frequency, capable of reproducing high sound level, not too difficult to fit into the environment, with a clear and defined midrange and high quality in high frequency reproduction.

System: Floor standing - front firing Reflex
Loudspeakers: 1 x 15” woofer
1 x 1.4 “ compression driver with titanium diaphragm
Numbers of ways: 2 way
Frequency Response: 30-20000 Hz
Cross-over: Woofer low-pass 12 dB
Tweeter high- pass 6 dB
Crossover Frequency 800 Hz
Power: 500 watt RMS
Amplifier: from 10 to 200 Watt RMS or more – without clipping
Sensibility: 96 dB @2.83Vrms/1 meter
Nominal impedance: 8 ohm ( 7.4 ohm min )
Size: 101h x 43,5w x 54d cm
Weight: 60 Kg each
When you call please mention you found this ad listing on OKz.ca