STORE LOCATION: 545 TELFER St S, Winnipeg, MB R3G 2Y4

https://altitudoaudio.ca/products/tw-ad-8300-11-channel-amp-3x300w-8x155w-8-ohms

AD-8300PA is eleven channels amplifier that specially designed to use with your current AVR receiver or multi channel AV processor.

CIRCUIT TOPOLOGY
Fully modular audio power amplifier with a high-efficiency switch mode power supply (SMPS), independent, fully discrete, dual differential, high current, short signal path 150 Watts Class A/B amplifier modules, Optimized 300 Watts Class H amplifier modules and microprocessor-controlled fault protection.

AUDIO SPECIFICATIONS
AD8300 features three of our 300 Watts High-Powered Single Channel Modules & Eight 150 Watts Amplifier Modules.

AUDIO SPECIFICATIONS (HIGH-POWERED SINGLE CHANNEL MODULES): LCR CHANNELS & SURROUND CHANNELS
LCR Channels 350 Watts & LS,RS,LBS,RBS 155 Watts RMS/channel; 20 Hz – 20 kHz; THD<0.1%; 8 Ohms; one channel driven
LCR Channels 605 Watts & LS,RS,LBS,RBS 276 Watts RMS/channel; 20 Hz – 20 kHz; THD<0.2%; 4 Ohms; one channel driven
LCR Channels 320 Watts & LS,RS,LBS,RBS 150 Watts RMS/channel; 20 Hz – 20 kHz; THD<0.1%; 8 Ohms; Two channel driven
LCR Channels 516 Watts & Surround Modules 207 Watts RMS/channel; 20 Hz – 20 kHz; THD<0.1%; 4 Ohms; Two channel driven
LCR Channels 240 Watts & Surround Modules 105 Watts RMS/channel; 20 Hz – 20 kHz; THD<0.1%; 8 Ohms; all channel driven
Power Bandwidth (at rated power; 4 Ohm - 8 Ohm load): 10 Hz to 20 kHz ( / – 0.1 dB)
Broadband Frequency Response: 1 Hz to 89 kHz 0/-2 dB.THD noise: < 0.009%; at 100 watts RMS; 1 kHz; 8 Ohms
Signal to Noise Ratio (8 Ohm load):
> 111 dB; ref FTC rated power; unbalanced input (A-weighted).
> 86 dB; ref 1 watt; unbalanced input (A-weighted)
Minimum Recommended Load Impedance (per channel): 4 Ohms (which equals one 4 Ohm load or two paralleled 8 Ohm loads)
Damping Factor (8 Ohm load): 141
Gain: 29.3 dB
Maximum Power Consumption: 2,540 watts.
2 Years Warranty


Input Impedance:
20 kOhms (balanced).
15 kOhms (unbalanced).
INPUT AND OUTPUT CONNECTIONS
Input Connections (High-Powered independent L C R Channel Modules):
L C R 3 way main channels selectable balance / unbalance inputs
Input Connections (Independent Surround Channel Amplifier Modules):
8 way surround channels selectable balance / unbalance inputs
Speaker Output Connections: Audiophile grade, gold plated, 11-way binding posts.
Trigger Input: 5 – 12 V (AC or DC)
Trigger Output: 12V DC
Power Requirement Between 115V/230V @ 50 / 60 Hz (automatically detected).
FRONT PANEL CONTROLS AND INDICATORS
Standby: push button (halo ring changes color to indicate Standby or On)
Status LEDs change to flashing red to indicate a fault condition.
REAR PANEL CONTROLS
Over current circuit breaker: press button to reset circuit breaker.
PROTECTION :
-> AD-8300 is protected against excessive operating temperature, shorted speaker connections, ground faults, and other common fault conditions.

-> The Amplifier has over heat protection, DC protection, short circuit protection, over load protection

-> For the high frequency transformer used on power supply: It has overheat protection, overload protection, short protection, over voltage protection and under voltage protection

-> Fan: The speed of the fan is determined by the temperature within the unit. At lower temperature the fan will be off, When the temperature increases the fan will auto detect and increase the speed to control the temperature of the unit

Dimensions:

431 mm width x 197 mm height x 472 mm depth

Weight: 20.5 kg - 45.20 lbs (unboxed).
22.8 kg - 50.27lbs (boxed).
When you call please mention you found this ad listing on OKz.ca